Onicon F-5100 Inline Manuel d'utilisateur télécharger pdf (Page 9)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-5100 Inline Thermal Mass Flow Meter Manual 05/15 - 0686-11 / 18332 Page 9

SECTION 3.0: INSTALLATION

The drawings above illustrate the relationship between the integral display, the ow direction

and the orientation of the meter when installed in the pipe. Contact ONICON for assistance if

this relationship does not allow for viewing the display.

WARNING

This ow meter may be installed in pipes which are under high pressure or pipes lled with

combustible gases. Accidents with these systems can cause serious injury or death. Only persons

experienced with high pressure and/or combustible gas distribution systems and uid metering

should attempt to install, adjust, or remove the ow meter. Please read all instructions carefully

before attempting to install or service a ow meter.

ONICON will be happy to assist with technical recommendations and to provide guidance by phone

or e-mail. On-site eld engineering, installation and service are also available at an additional cost.

3.1 INSTALLATION SITE SELECTION

Install the ow meter where it will be accessible for personnel to perform necessary periodic

maintenance. The clearance required for installation is a minimum of 9” from the pipe wall

to the nearest obstruction above the electronics enclosure. Refer to Section 1.5 WORKING

ENVIRONMENT for additional considerations.

ONICON inline style ow meters must also be correctly oriented in the pipe with respect

to the direction of ow. On meters with an integrally mounted display, this will affect the

orientation of the display.

Flow

WARNING

DO NOT LOOSEN

THESE FITTINGS

WARRANTY VOID

IF REMOVED

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Pas de commentaire

Onicon F-5100 Inline Manuel d'utilisateur Page 9