Onicon F-2600 Manuel d'utilisateur télécharger pdf (Page 54)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-2600 & F-2700 Vortex Flow Meter Manual 02/15 - 0808-7 / 19204 Page 54

3.2 START-UP

To begin ow meter operation:

1. Verify the ow meter is installed and wired as described in Section 2.

2. Apply power to the meter. At start-up, the unit runs a series of self-tests that check the RAM,

ROM, EPROM and all ow sensing components. After completing the self-test sequence, the

Run Mode screens appear.

3. The Run Mode displays ow information as determined by system settings. Some screens

depicted on the next page may not be displayed based on these settings. Press the ⇑ ⇓ arrow

keys to view the Run Mode screens.

4. Press the ENTER key from any Run Mode screen to access the Set-up Menus. Use the Set-up

Menus to congure the meter’s multi-parameter features to t your application.

IMPORTANT NOTICE

Starting the ow meter or pressing EXIT will always display the Run Mode screens.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 130 131

Pas de commentaire

Onicon F-2600 Manuel d'utilisateur Page 54